Creating a BareMetal node group for Extend: Managed Service for Kubernetes®
Getting started
For the BareMetal item to appear in the node group creation menu, do the following:
- Create a Managed Service for Kubernetes 1.35 cluster with Cilium tunnel mode (Cilium CNI) enabled, or make sure an existing cluster meets these requirements. Tunnel mode can only be activated at the step of creating a cluster.
- Check the cluster network settings to get the cluster CIDR and service CIDR.
- Set up a private BareMetal subnet. Make sure it belongs to a VRF and DHCP is enabled in its settings. If there is no suitable subnet, create one.
- Create a private connection between the VRF and cloud network hosting the Managed Service for Kubernetes master. Use a virtual Cloud Router for the connection.
- Add the cluster CIDR and service CIDR to the virtual router as announced IP prefixes of the master's cloud network.
Create a node group
-
In the management console, select the folder.
-
Navigate to Managed Service for Kubernetes.
-
Select the cluster.
-
Go to the Cluster management tab and select the Node group section.
-
Click Create a node group and select BareMetal.
-
In the Select a BareMetal configuration step:
- Specify Nodes per group. This value is used to select configurations with sufficient number of available servers and does not define the group size. You can set the group size in the next step.
- Select a server configuration with appropriate CPUs, RAM, and disk type and size.
The availability of configurations depends on the server pool. A private subnet connects servers from the same pool, so in the next step, select a subnet from the pool where the selected configuration is available.
-
In the Node group setup step:
-
Specify a node group name. Optionally, add a description and labels.
-
Make sure the Kubernetes version field is set to
1.35. -
Optionally, update Nodes per group.
-
Under Network interfaces, in the Private subnet field for the first interface, select the subnet you set up from the pool where the selected configuration is available. The subnet must have DHCP enabled, and the subnet VRF must be connected to the master's cloud network.
-
If your nodes require internet access, enable Internet access for the second interface. Public IP addresses will be assigned automatically. Internet access is optional for the BareMetal node group.
-
Configure Maintenance frequency / Disable and specify Maximum unavailable nodes.
-
Add Node taints and Node labels as needed.
-
-
Click Create a node group.
After the node group is created, Extend: Managed Service for Kubernetes® will rent the selected number of servers, configure them, and connect them to the cluster. The group will appear in the list of node groups of the BareMetal type.